IGCSE Maths 0580: final exam countdown
A 14-day checklist for the run-up to the exams: the topics Examiner Insights ranks highest, the most common mistakes, then a full timed paper. Tick each day off; your ticks are saved in this browser only.
Paper 1: confirmed dates
Cambridge sets the 0580 dates for each administrative zone, so we show no single countdown. Cambridge had not published the June 2027 timetable when we last checked (5 October 2026). Check your board’s timetable: Cambridge timetable · our exam dates page.
Your 14-day checklist
- Day 1
Accuracy: keep full values, round once, 3 s.f. and 1 d.p. for angles
Revise
Both accuracy points come from the report's general comments, so they apply to every paper; on Papers 3 and 4 they can cost marks on almost any question.
- Day 2
Combined events: multiply along a route, add different routes
Revise
A combined-probability question on Paper 0580/22 was answered well by only a minority of candidates in June 2024.
- Day 3
Units in area and volume (cm, m, litres)
Revise
Very few candidates converted units correctly in a June 2024 volume question, and the 2025 specimen commentary also stresses checking units.
- Day 4
Map scales and bearings
Revise
Both are named among the topics Core candidates found challenging in June 2024.
- Day 5
Inverse and composite functions (Extended)
Revise
Cambridge's commented answers for the 2025 specimen papers single out both; functions are an Extended-only sub-topic.
Notes · Practise 0580 Algebra and graphs · What the examiners say
- Day 6
Standard form and surds
Revise
Standard form was named as challenging on a June 2024 Core paper; surds are on the non-calculator Extended paper from 2025.
- Day 7
Speed-time graphs: gradient, area and units
Revise
The specimen Paper 4 commentary flags the units and the sign of a deceleration.
Notes · Practise 0580 Algebra and graphs · What the examiners say
- Day 8
No working, so no part marks
Check this mistake
The June 2024 report's general comments say working was often missing or unclear. Without it a wrong answer scores nothing, while shown steps can still earn method marks; the Core key messages ask for each step of a multi-step calculation to be shown separately.
Fix: Write one line per step (what you work out, then the number). Keep going to the answer even if you are unsure of an earlier step.
Read more on Examiner Insights, then find one question where you made it in My mistakes.
- Day 9
Rounding in the middle of a calculation
Check this mistake
Reported in the June 2024 general comments: candidates used a correct method but rounded an intermediate value, so the final answer fell outside the accepted range.
Fix: Keep every intermediate value in the calculator (use the memory or ANS key, or write at least 4 or 5 significant figures). Round only the final answer.
Read more on Examiner Insights, then find one question where you made it in My mistakes.
- Day 10
Ignoring the 3 s.f. (1 d.p. for angles) accuracy rule
Check this mistake
The June 2024 general comments note that a number of candidates ignored the instruction to give non-exact answers to 3 significant figures, or 1 decimal place for angles in degrees.
Fix: Unless a question says otherwise, give non-exact answers to 3 significant figures and angles in degrees to 1 decimal place. Write the longer calculator value first, then the rounded answer.
Read more on Examiner Insights, then find one question where you made it in My mistakes.
- Day 11
Combined events: adding where you should multiply
Check this mistake
The June 2024 report on Paper 0580/22 describes a combined-probability question answered well by only a minority: wrong products were common and some candidates added probabilities where they should have multiplied.
Fix: For A and then B (independent) multiply. Add only to combine different outcomes that cannot both happen. A tree diagram makes each route clear.
Read more on Examiner Insights, then find one question where you made it in My mistakes.
- Day 12
Mixing units in area and volume
Check this mistake
On Paper 0580/22 (June 2024) a volume question was not well answered: some candidates noticed the units were not consistent, but very few converted them correctly.
Fix: Convert every length to the same unit before you multiply. Remember 1 litre = 1000 cm³, 1 m = 100 cm and 1 m³ = 1 000 000 cm³.
Read more on Examiner Insights, then find one question where you made it in My mistakes.
- Day 13
Sit a past paper (Core: Papers 1 and 3; Extended: Papers 2 and 4) under timed conditions
Full paper
Prediction Papers (with an IGCSE plan or the free 7-day trial; without a plan you can see each paper's format and marks). Or a paper from the past papers.
- Day 14
Formula sheet, equipment and an early night
Last day
Read the formula sheet once, pack your equipment, and stop revising early.
More for the final weeks
- Examiner Insights
- Skill Builders
- Question of the Day a few minutes a day
- Revision timetable fit the checklist around school
- Exam dates
Other plans for IGCSE Maths 0580: Mock prep · Back to school · Results day · 30-day challenge · Mock Season Plan (free, 4 weeks) · Final 6 Weeks (free plan) · all exam-season plans